Search
Search Only:

Search Keyword rotors

Total: 6 results found.

... are contacting; or the anti-squeal shims have been removed by a previous brake job; or the current brake pads' material is cheap quality; or the rotors are pitted/grooved/rusted/warped. To eliminate the ...
Monday, 08 September 2008
... are just like any other car. The rotors are steel and the service manual states they can be machined, up to .080" under the "new" specification. The rear drum brakes are also ordinary, other than the ...
Wednesday, 03 September 2008
... to reinstall any of this. We reinstalled the oil pump shaft and new rotors and back cover. After some debate, I talked Scott into priming the oil pump with a small dab of Vaseline, despite no instructions ...
Wednesday, 03 September 2008
4. In-house Machine Shop
(About Arts/Behind the Scenes)
... cuts flywheels much faster and leaves an attractive sharp step on the flywheel and a very nice finish. Brake Rotor and drum resurfacing We recommend resurfacing the brake rotors any time the pads ...
Wednesday, 03 September 2008
5. What is Maintenance?
(FAQs/Maintenance FAQ)
... System Maintenance: This is what many people think of when they think of a "tune-up". The ignition system has parts like spark plugs, distributor caps, distributor rotors, ignition wires. While these ...
Wednesday, 03 September 2008
... before the brakes went metal to metal, now may need to be replaced. Rotors will eventually wear to below the minimum thickness even if the pads do not go metal to metal. However, letting the pads wear ...
Tuesday, 02 September 2008